FILES

Moonflex diamond files must be used wet, spraying a mixture composed of  50% water and 50% alchool directly on the tool while used. If used on ski slopes, a little bit of snow would be enough  to keep the file wet.

To get the best finishing of the edges, we suggest the following recommendations: the corner of the edges should be first profiled using a Moonflex grit 100 (black), then polished using the range of grids 200-400-600-1500 to get a mirror-like surface. For further lapping, resin bond  Moonflex grit 1500/3000 is suitable.

Moonflex should never be used freehand; always use a suitable holding device to keep the Moonflex diamond file steady and perfectly aligned with the edges. After using it, we recommend to clean Moonflex with a brass brush and the same mixture of water and alchool used while sharpening the edges. If used properly, a Moonflex file will allow you to tune some hundreds edges.

BELTS

Moonflex belts are used in the machining of ski edges with manual-feed or automatic belt sanders, for both tuning edges and grinding side edges purposes.

These belts are available in grits 60-100-200-400-600-1500 and in any lengths or widths, making them suitable to any machines.

Using Moonflex  belts you’ll be granted the following results:

• Perfect removal of nicks and rust, according to the grit used;

• no heating of edges;

• perfect surface;

• perfect angles, with extremely sharp corners;

• long tool life;

• possibility to machine any type of steel.